Advertisement
B. Reverse door swing
(optional)
If not changing door swing, go to
"C. Check door seal."
Be careful not to scratch or chip paint.
1.
Place a large towel or soft cloth on
top of wine cellar.
2.
With wine cellar door closed, first
remove bottom hinge screws and then
top hinge screws from cabinet with a
rachet wrench. Grasp sides of door and
lift door off cabinet. Do Not lift door by
handle. Carefully set door on top of
wine cellar with handle side up.
C. Check door seal
Door must be squared to the cabinet
to ensure proper seal.
D. Attach grille
handle
screws
3.
Remove the handle screws from top
of door.
hinge
screws
4.
Remove top hinge from door. Turn top
hinge upside down and attach it on bottom
of door opposite the bottom hinge.
door
seal
1.
Pull control knob to remove.
2.
Use a 7/16" rachet wrench to remove
the screw next to control knob.
3.
Hook two tabs on bottom of grille
over edge of wine cellar base. Push grille
into place.
5.
Turn bottom hinge upside down and
hinge
attach it on the top, opposite corner of
door.
top
hinge
6.
hinges were removed from door.
7.
hinge holes in cabinet. Insert screw hole
plugs in hinge holes on opposite side of
cabinet.
8.
with holes in cabinet. Attach door at
top and then at bottom with screws.
1.
check for proper seal and to make sure
door looks level. If door is not level:
• Loosen (do not remove) the top hinge
• Realign door so that it is squared to
• Tighten hinge screws.
control knob
hole
tabs
4.
5.
rods on wine cellar base. Push control
knob into place. Do Not force the control
knob.
Remove bottom hinge from door.
plugs
Install handle screws in holes where
Remove screw hole plugs from top
Grasping sides of door, align hinge
Slowly open and close door to
screws.
cabinet.
screw hole
Reinstall grille screw.
Align openings in control knob with
bottom
hinge
handle
screws
Advertisement
