Assembly - Craftsman Nextec 320.61326 Operator's Manual

BATTERY FULL
If the battery pack is within normal temperature range, the green LED will
illuminate and the red LED will be off. The battery pack is fully charged and
ready to use. The battery pack will fully charge, but will not overcharge, if left on
the charger.
NOTE: Charger may warm with several continuous charge cycles. This is part of
the normal operation of the charge. Charge in a well ventilated area.
TO ATTACH BATTERY PACK (Fig.4}
NOTE: Depress the OFF switch Fig. 4
before attach the battery pack
on the sander.
• Align the raised rib on
the battery pack with the
grooves of the sander, and
then attach the battery pack
to the sander.
NOTE: Make sure that the
latch on the battery pack snaps
into place and that the pack
is secured to the tool before
beginning operation.
TO DETACH BATTERY
PACK (Fig. 4}
NOTE: Depress the OFF switch before attaching the battery pack to the sander.
1. Depress the battery release buttons located on the both sides of the battery
pack to release the battery pack.
2. Pull the battery pack out and remove it from the tool.
,_ CAUTION: When placing the battery pack in the tool, be sure that the raised
rib on battery pack aligns with the groove inside the sander and that the latches
snap into place properly. Improper assembly of the battery pack can cause
damage to internal components.
61326 Manual_Revised_10 0226 Page 14