Turning The Sander On/Off; Led Worklight - Craftsman Nextec 320.61326 Operator's Manual

TURNING THE SANDER ON/OFF (Fig.5)
1. Attach the battery pack to Fig. 5
the sander.
2. To turn the sander ON,
depress the ON switch.
3. To turn the sander OFF,
depress the OFF switch.
FueIGauge (Fig.5)
This tool is equipped with a
FuelGauge which indicates the
battery pack charge level.
The green LED on the
FuelGauge indicates that the
battery is fully charged.
The orange LED on the
FuelGauge indicates that the
battery has used approximately
one half of its charge.
The red LED on the
FuelGauge indicates the
battery pack is depleted and
needs to be charged.
LED WORKLIGHT (Fig. 6)
The LED worklight located
on the front of the sander will
turn on when the ON switch is
pressed. The LED worklight will
turn off when the OFF switch
FuelGauge
Fig. 6
LED worklight
is pressed. This provides additional lighting on the surface of the workpiece for
operation in lower light areas.
,_ WARNING: The worklight aids in illuminating the cut-line. It is NOT a
substitute for adequate work-area lighting. Failure to obey this warning could
cause serious personal injury.
61326 Manual_Revised_lO 0226 Page 15