Craftsman Nextec 320.61326 Operator's Manual page 17

VACUUM ADAPTER (Fig.8)
Always connect the vacuum i[ Fig. 8 I
adapter when sanding.
Remove the battery pack from
the sander before mounting the
vacuum adapter. To improve dust
extraction from the working area,
insert the adaptor into the rear of
the sander, and connect adapter
to a suitable vacuum cleaner.
,_k WARNING: For long
periods of working with wood
or on materials that produce
dust that is detrimental
to health, the tool is to be
connected to a suitable external
dust extraction device.
WARNING: The dust that is produced while sanding can be detrimental
to health, flammable, or explosive. Suitable safety measures are required.
Examples: Some dusts are regarded as carcinogenic. Use suitable dust/chip
extraction and wear a dust respirator.
From time to time, clean the dust-exhaust openings with a dry brush. Clean the
housing only with a damp cloth; do not use any solvents. Dry thoroughly afterwards.
SELECTING THE RIGHT GRADE OF SANDPAPER (SOLD SEPARATELY)
Different grades of sandpaper can be purchased from the store where you
purchased the tool. Available grades are: Coarse, Medium and Fine.
Use a coarse grit to sand down rough finishes, medium grit to smooth the work
and fine grit to finish off.
It is best to make a trial run on a scrap piece of material to determine the
optimum grades of sandpaper for a particular job.
Sandpaper GRiT CHART
Grit Type Example of use
60 or less Very Coarse Material removal, heavy paint removal, shaping
wood
80 - 100 Coarse Paint removal, rough surface preparation (e.g.,
non-planed wood)
120 - 150 Medium Surface preparation planed wood
180 - 220 Fine Sanding between coats
240 or more Very Fine Final finishing
6:$326 Manual_Revised_lO 0226 Page 17