Advertisement
ASSEBa.BLY
CONNECT
BAT _ER'_ 0see Fig. 2}
CAUTION:
Do not short battery termi.,
rials+
Before
connecting
bakery,
re._
move
metal
bracelets,
wristwatch
bands, rir_gs, etc,
Positive
terminal
must
be connected
first to prevent
sparking
from
acciden-.
ta! grounding_
_,
Lift hood to raised position,
o
Open terrninaI access doors, remove terminal protec-
tive caps and discard.
o
tf this battery is put into service after month and year
indicated on label (label located between terminals_
charge battery for' minimum of one hour at G10 amps.
o
First connect RED battery cable to positive (+) battery
terminal wilh hex bolt, flat washer, lock washer and hex
nut as shown.
Tighten securely
o
Connect BLACK grounding cable to negative (-) battery
terminal with remaining
hex bolt, flat washer, lock
washer and hex nut.. Tighten securely.
o
Close terminal access doors.
Use termina! access doors for:
o
Inspection for secure connections
(to tighten hard_
ware)
o
Inspection for corrosion.
o
Testing battery
o
Jumping (if required)
o
Periodic charging.
INSTALL
SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
o
Remove cardboard packing on seat pan..
o
Place seat on seat pan and assemble shoulder bolt
o
Assemble adjustment knob and flat washer loosely.
Do not tighten_
Tighten shoulder bolt securely
o
Lower seat into operating position and sit on seat..
o
Slide seat until a comfortable position is reached which
allows you to p_ess clutch/brake
pedal all the way
down
o
Get off seat without moving its adjusted position..
o
Raise seat and tighten adjustment knob securely.
SEAT
SEAT PAN
SHOULDER
BOLT
ADJUSTMENT
KNOB
FIG. 3
FLAT WASHER
FIG, 2
8
Advertisement
