Assembly - Craftsman 919.167312 Owner's Manual

g
Contents of Carton
1 - Air Compressor
2- Wheels
2 - Shoulder Bolts, 3/8-16
2 - Nex Nuts, 3/8-16
2 - Rubber Bumpers
2 - Screws, 1/4-20 x 3/4
Assemble Wheels
It win be necessary
to brace or support
one side of the air compressor
when installing the wheeBs because
the compressor will have a
tendency to tip,
1. Attach wheels with shoulder
bolts and nuts as shown.
Tools Required for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
Unpacking
1_ Remove a!l packaging leaving
the air compressor on the pallet.
2. Remove and discard the
(4) screws holding the air
compressor to the palleL
_} Rubber
Feet
, Screw
Wheel
Shoulder
Belt
one side of the air compressor
when removing the pallet because
the air compressor win have a
tendency to tip,
3. Carefully remove the air
compressor from the pallet.
2. Tighten securely. NOTE: The air
compressor wilI sit level if the
wheels are properiy installed.
The wheems and
handme do not
provide adequate c_earance,
stability or support for pulling the
unit up and down stairs or steps,
The unit must be mifted, or pushed
up a ramp,
Assembme Rubber Feet
1. Attach rubber feet with the
screws provided as shown in
previous figure.
2. Tighten securely.
A09707 10-ENG