Craftsman 152.221140 Owner's Manual page 116

BOLTING TABLE SAW TO THE FLOOR
MAKE CERTAIN the table saw is disconnected from
the power source.
If you wish, the table saw can be permanently mounted
to the floor. To attach to the floor, see instructions
below.
Figure 15A=1
B
2,
3,
4,
5,
Remove the four rubber footpads (A) from the table
saw legs (B). See Figure 15A-1.
Position the table saw where you want it perma-
nently mounted.
Mark the floor through the holes in the bottom of
legs.
Move the table saw out of the way and drill pilot
holes at the four locations marked.
Attach the table saw to the floor using appropriate
hardware (not included).
24