Craftsman 152.221140 Owner's Manual page 101

AVAILABLE ACCESSORIES
Visit your Sears Hardware Department or see the Sears
Power and Hand Tool Catalog for the following acces-
sories.
ITEM STOCK NUMBER
* Auxiliary Fence, Rip Fence 29878
* Miter Gauge Extension & Stop 29879
* Stock Clamp, Miter Gauge 29880
* Dust Chute with Dust Port 22102
* Micro-Adjustment Assembly 29881
* Table Insert - Standard 29882
* Table Insert - Dado 29885
* Table Insert - Molding Cutterhead 29887
* Saw Blade - Leitz, 10-in. x 40 tooth 29888
variable pitch blade
* Fence Guide System 32371
Sears may recommend other accessories not listed in
this manual.
See your nearest Sears Hardware Department or Sears
Power and Hand Tool Catalog for other accessories.
Do not use any accessory unless you have completely
read the Owner's Manual for that accessory.
Use only accessories recommended for this table saw.
Using other accessories may cause serious injury and
cause damage to the table saw.
Fig. 2A
CONSTRUCTING A FEATHERBOARD
24"
5"
Figure 2A illustrates dimensions for making a typical
featherboard. The material, which the featherboard is
constructed of, should be straight piece of wood that is
free of knots and cracks. Featherboards are used to
keep the work in contact with the fence and table and
help prevent kickbacks. Clamp the featherboard to the
fence and table so that the leading edge of the feather-
board will support the workpiece until the cut is com-
pleted.
Fig. 2B
Use featherboards for all non-through cutting opera-
tions where the guard and splitter assembly must be
removed. Always replace the guard and splitter
assembly when the non-through cutting operations
are finished. See figure 2B.