Craftsman 580.753410 Owner's Manual page 6

Yourpressure washer requires s omeassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withtherecommended oil andfuel.
If you haveanyproblemswith the assemblyof
your pressurewasher,pleasecallthe pressure
washerhelp{ine at 1-800-222-3136,
IMPORTANT: Anyattempt t o runtheenginebefore it
hasbeenserviced withthe recommended oilwill result
in anengine failure.
REMOVE PRESSURE WASHER
FROM CARTON
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
• Remove fillers, accesories and parts bag shipped
with your pressure washer.
• Roll pressure washer out open end of carton.
• Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• The main unit
Handle
Spray gun
High pressure hose
Nozzle extension with quick connect fitting
Engine oil
Parts bag (which includes items listed below)
, Owner's manual
• Registration card
• Bag containing 5 multi-colored quick connect
spray tips
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolt (2)
• Plastic Knobs (2)
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1.800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Fill out and send in registration card.
2. Attach handle.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Verify oil dipstick has been installed into pump.
Pump Oil Dipstick
6. Connect pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle
extension.
Attach Handme
1. Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
f
\
Handle s
Align Holes _/'*
Handle i
// Supports /
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand.
3. Insert multi-colored spray tips in spaces provided
in handle.