Craftsman 580.753410 Owner's Manual page 12

4. Makesureblackspraytip is instalJed.
NOTE: D etergent cannot b eapplied withthe high
pressure spraytips(White, G reen, Y ellow, o r Red).
5. Makesuregarden hoseis connected t owater
inlet.Check thathighpressure hoseis connected
tospraygunandpumpandstartengine.
6. Applydetergent toa drysurface, s tarting atJower
portion of areato bewashed andworkupward,
usinglong,even, o verJapping strokes.
7. Allowdetergent tosoakin between 3-5 minutes
before washing andrinsing. R eappiy a sneeded to
prevent s urface fromdrying.DONOTaJJow
detergent to dryon(prevents s treaking).
iMPORTANT: Youmustflushthe chemical injection
system aftereachusebyplacing thefilterintoa
bucket o f cJean w ater,thenrunthepressure washer in
lowpressure for1-2minutes.
Pressure Washer Rinsing
For Rinsing:
1. AppJy trigger Jock to spray gun.
2. Remove black chemical nozzle from nozzle
extension.
3. Select and install desired high pressure nozzle
folJowing instructions "How to Use Spray Tips".
4. Keep spray gun a safe distance from the area you
plan to spray.
WARNING
.
.
Keep spray nozzle between 8 to 24 inches away from
cleaning surface.
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure
washer from a ladder, scaffolding or any other relatively
unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
AppJy a high pressure spray to a smaJl area and
then check the surface for damage. If no damage
is found, you can assume it is okay to continue
rinsing.
Start at top of area to be rinsed, working down
with same overlapping strokes as you used for
cleaning.
Automatic Coot Down System
(Therma_ Relief}
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circulating water in the pump can reach
temperatures above 125°F. The system engages to
cooJ the pump by discharging the warm water onto
the ground.
12