Table of Contents
Advertisement
Receiver & Remote Control Programming
NOTICE: To comply with FCC rules, adjustment
or modNcation
of this
receiver and/or transmitter
are prohibited,
except for changing the code
setting or replacing the transmitter
battery. THERE ARE NO OTHER
USER SERVICEABLE
PARTS.
Your garage door opener has been factory set to operate
with the large push button on the remote control.
However, you can use either of the two small buttons, if
you prefer. And, the 3-function remote can also activate
additional garage door openers and/or light acontrols.
Your "SRT" garage door opener will operate with:
• up to four "SRT" relnote control translnitters (with
green indicator lights),
• a Keyless Entry System, and
• code switch relnote controls with red indicator lights.
Below are instructions for progralmning your opener to
match the other buttons on your remote control and any
additional relnotes you may purchase. See available
accessories on page 38.
To add a remote control:
1. Press and hold the selected remote push button, see
Figure 1.
2. Then press and release the "SRT" bmmn on the right
side panel of the opener, Figure 2. The opener lights
will flash otlce.
3. Release the remote push breton.
Now the opener will operate when the remote control
push button is pressed.
If you release the remote control push button before
the opener lights flash, the opener will not accept the
code.
To change the selected push button on the same
remote:
If you decide to use a different remote control button than
originally programmed into the opener, you need to erase
all the learned codes and reprogram each remote used to
operate the garage door opener.
To erase all remote control codes:
• Press and hold the "SRT" button on the opener panel
until the indicator light turns off (about 6 seconds). All
the codes the opener has learned will be erased.
• To reprogram, repeat Steps 1
3 for each remote
control in use.
Code programming
instructions
are also located
on
the opener
panel.
Childrenoperatingor playingwith a garagedoor opener
can injure themselvesor others. The garagedoor cou/d
c/ose and cause serious injury or death. Do not allow
childrento operatethe door control(s)or remotecontrol
transmitter(s).
A movinggaragedoor cou/d injureor ki//someoneunder
it. Activate the opener onlywhen you can see the door
clearly, it is free of obstructions, and is properly
adjusted.
Figure 1
Standard 3-Function Remote Control
Select a remote control push
button to operate opener
Figure 2
Garage Door Opener
(With "SRT" Button)
"SRT"
Indicator
Button
Light
f,%
33
Advertisement
Table of Contents
