Advertisement
Available languages
Available languages
Drain Valve:
I
The drain valve I
is located at
I
the base of the
a r tank and s
used to drain
condensation
at the end of each use.
Check Valve: When the air
compressor is operating, the check
valve is "open", allowing compressed
air to enter the air tank. When the
air compressor
reaches "cut-out"
pressure, the check valve "closes",
allowing air pressure to remain inside
the air tank.
Valve
How
to Use Your
Unit
How to Stop:
1.
Set the On/Oft switch to OFF (O).
Before
Starting
Break-in
Procedure
_lJ_
Risk of Unsafe
Operation.
Serious damage may result if the
following break-in
instructions
are
not closely followed.
This procedure is required before the
air compressor
is put into service and
when the check valve or a complete
compressor pump has been replaced.
1.
Make sure the On/Oft switch is in
the OFF (O) position.
2.
Plug the power cord into the
correct branch circuit receptacle.
(Refer to Voltage and Circuit
Protection paragraph in the
Installation section of this
manual.)
3.
Open the drain valve (counter-
clockwise) fully to permit air to
escape and prevent air pressure
build up in the air tank during the
break-in period.
4.
Move the On/Oft switch to ON (I)
position. The compressor will start.
5.
Run the compressor for 15
minutes. Make sure the drain
valve is open and there is minimal
air pressure build-up in tank.
6.
After 15 minutes, close the drain
valve by turning clockwise.
The
air receiver will fill to "cut-out"
pressure and the motor will stop.
The compressor
is now ready for use.
Before
Each Start-Up:
1.
Set the On/Oft switch
to OFF (O).
2.
Pull the regulator knob out and
turn counterclockwise
to set the
outlet pressure to zero.
3.
Attach hose and accessories.
NOTE: The hose or accessory will
require a quick connect plug if the
air outlet is equipped with a quick
connect socket.
13 _ ENG
A17298
Advertisement
