To Replace Headlight Bulb; Interlocks And Relays; To Replace Fuse; To Remove Hood And Grill Assembly - Craftsman 917.251572 Owner's Manual

Pull bulb holder out of the hole in the backside of the
grill
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
Close hood.
................................... i ,,,u .....
ADJUSTMENTS
, i n,,lu, ,,nnni
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 34)
• Raise hood.
° Unsnap headlight wire connector.
• Stand in front oftractor, Grasp hood at sides, tilt toward
engine and lift off of tractor.
• To replace, reverse above procedures.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting°
o Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual
TO REPLACE FUSE
Replace with 30 amp automotive-type p!ug-in fuse_ The
fuse holder is located behind the dash.
TO ADJUST ATTACHMENT LIFT SPRING
(See Fig. 33)
o White holding spring bushing with wrench, loosen jam
nut.
, Turn adjustment bolt clockwise to extend spring and
reduce lift effort for heavier attachments.
= Turn adjustment bolt counterclockwise for lighter at-
tachments
, Retighten jam nut against spring bushing.
IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER. ADJUST LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING,
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION.
HOOD
HEADLIGHT
WIRE
CONNECTOR
\
) ,,
• (,
FIG. 34
ADJUSTMENT
SPRING BUSHING
e ATTACHMENT
JAM NUT LIFTSPRING
o o
FIG. 33
26