Connect Battery; Install Seat; To Attach Nose Roller - Craftsman 917.251572 Owner's Manual

i Ul , , , ii ,i ,, , i i,,i i,,i u, , ii i,ii ,,,lUl ii, ,lllllllll,lllllll
LY
H_
CONNECT BATTERY (See Fig. 2)
CAUTION: Do not short battery termi-
nals. Before connecting battery, re-
move metal bracelets, wristwatch
bands, rings, etc_
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
• Lift hood to raised position,
o Open terminal access doors, remove terminal protec-
tive caps and discard,
= If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-t0 amps.
= First connect RED battery cable to positive (+) battery
terminal with hex bolt, flat washer, lock washer and hex
nut as shown Tighten securely
o Connect BLACK grounding cable to negative (-) bat-
tery terminal with remaining hex bolt, fiat washer, lock
washer and hex nut° Tighten securely.
° Close terminal access doors,,
Use terminal access doors for:
o Inspection for secure connections (to tighten hard-
ware).
- Inspection for corrosion.
- Testing battery,,
• Jumping (if required)_
Periodic charging,
LOCK FLAT
HEX NUT WASHER WASHER
DISCARD TERMINAL HEX,"
_ROTECTIVE CAPS BOLT
POSITIVE
(RED)
CABLE
NEGATIVE
(BLACK)
CABLE
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
Remove cardboard packing on seat pan,
• Place seat on seat pan and assemble shoulder bolt.
= Assemble adjustment knob and fiat washer loosely,,
Do not tighten,
° Tighten shoulder bolt securely,
• Lower seat into operating position and sit on seat°
• Sfide seat until a comfortable position is reached which
allows you to press clutch/brake pedat all the way
down.
. Get off seat without moving its adjusted position.
• Raise seat and tighten adjustment knob securely,
SEAT
SHOULDER _ _\ \r'T"'_ \' \\ \
ADJUSTMENT
KNOB
FIG. 3
TO ATTACH NOSE ROLLER (See Fig. 4)
• Position brackets, 17/32 x 7/8 x 16 gauge washers, and
nose rolter between deck mounting brackets as shown.
Be sure to position brackets on correct side, as shown°
• Install 3/8-16 x 1 hex bolts and 3/8-16 crownlock nuts
as shown_ Tighten hardware securely.
NOTE: Be sure bracket tabs are positioned in tab holes in
deck brackets.
"B"BRACKETTAB
,I
HEX
"A" CROWNLOCK
BRACKET NUT
TAB WASHER
FIG. 4