Initialization Of The Microprocessor - Denon ADV-1000 Operating Instructions Manual

[] LAST FUNCTION MEMORY
• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory This function provides memory storage when the power switch is off and with the power
cord disconnected
[] INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
Press the power button to set the ON,STANDBY
standby mode, then unplug the set's
power cord from the wall power outlet.
Hold the following PLAY (1_) button and STOP (11)button, and
plug the AC cord into the outlet
Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
h T ,,
1 2 2
NOTES:
• If step 3 does not work, start over from step t.
• If the microprocessor _s reset, all the buttons and the setup
settings are reset to the factory default values.
84