Oki C9800hdn Configuration Manual page 123

5
5-23 Network Setup
Server Name. —Enter the server name that will appear on the network. You can use
the same name as the server name assigned to the Fiery (see page 5-3), or choose
another name.
Comment. —Enter information about the printer, up to 15 characters.
These comments are listed in the Properties of the Fiery in Network Neighborhood.
Lowercase letters are allowed in this field.
Domain or Workgroup. —Enter the workgroup or domain where the Fiery should
appear.
Auto IP. —If you have already enabled Auto IP in Protocol Setup, and selected either
DHCP or BOOTP as the protocol for obtaining an IP address, select this option to
allow the Fiery to obtain the IP address automatically for the WINS Name Server. If
you do not select this option, use the following two options to specify whether to use a
WINS Name Server and its IP address.
Use WINS Server. —Select to use a WINS name server. Broadcasts from SMB
devices cannot be routed beyond their original network segment without a WINS
name server. Setting up a WINS name server is outside the scope of this manual. To
find out if a name server is available, contact your network administrator.
IP Address. —Enter the IP address of the WINS name server.
HTTP Connection Support (WWW)
Enable Web Services. —Select to make the WebTools available to users
(see page 6-2). TCP/IP must already be enabled on the Fiery and on users' computers.
The WebTools include Status, WebLink, WebSetup, WebScan, and WebDownloader.
A Java-enabled Web browser and a valid IP address are required for each user. For
details on supported browsers and workstation requirements, see the User Software
Installation Guide.
Enable Internet Printing Protocol (IPP). —Select to enable printing with the IPP.
You must also enable Web Services. For information on setting up users' computers to
use IPP printing, see Chapter 1 of the User Software Installation Guide.