Setting the System Option Modes
The HP service representative sets the System Option Mode(s) based on the operating
system and software configuration of the host.
Configuring the Fibre Channel ports
Configure the disk array Fibre Channel ports by using Remote Web Console (shown),
Command View, or Command View XP AE. Select the settings for each port based on
your storage area network topology. Use switch zoning if you connect different types of
hosts to the array through the same switch.
Fibre Address
In fabric environments, the port addresses are assigned automatically. In arbitrated
loop environments, set the port addresses by selecting a unique arbitrated loop
physical address (AL-PA) or loop ID for each port. For specific values, refer to the HP
StorageWorks LUN Configuration and Security Manager XP User Guide.
16
Installation