Check Access Point To Be Used Screen Is Displayed; Check Settings Screen Is Displayed - Canon PIXMA MX410 Network Setup Manual

Check Access Point to Be Used Screen is Displayed

Action
The message appears when multiple access points
with the same name are found.
When you have only one access point
The access point selected in the Detected Access
Points List screen will be used. Make sure that the
target access point is selected correctly by following
the procedure below, then proceed with the setup.
1
Click Cancel or Back (A).
• Detected Access Points List screen returns.
2
Select the access point name/network name (SSID) that matches the MAC
address of the target access point, then click Connect.
• The Check Access Point to Be Used screen is displayed.
• For details on how to check the MAC address of the access point, refer to the manual
supplied with the access point or contact its manufacturer.
3
Select Use one access point (B), then click OK or Continue (C).
When using multiple access points (roaming)
To use roaming, select Use multiple access points (D), then click OK or Continue
(C).
Glossary
• MAC address
A unique number assigned to each network device.
• SSID
An identifier to identify the specific access point. Also called an access point name or a network name.
• Roaming
A function to provide seamless communication when multiple access points with the same SSID are in
use by automatically connecting to another nearby access point upon interruption of signals from the
current one.

Check Settings Screen is Displayed

B
D
C A
Check
The screen appears when an IP address was not
obtained automatically due to incorrect network key or
inactive DHCP function.
It may also appear when using the MAC address
filtering feature or the firewall function.
Check 1
If the network key is incorrect, enter the network key
again and click Connect (A).
• For details on how to check the network key of the access point, refer to the manual supplied with
the access point or contact its manufacturer.
Check 2
Make sure that the DHCP function of the access point is active.
• For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
If the DHCP function is inactive, enable the DHCP function of the access point or
specify the IP address of the machine, then click Connect (A).
• For details on how to change the settings of the access point, refer to the manual supplied with
the access point or contact its manufacturer.
• To specify the IP address of the machine, click Set IP Address (B), then follow the procedure in
Check 4 of "Set Printer IP Address Screen is Displayed" on page 4.
Check 3
Is the MAC address filtering enabled on the access point?
• For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
A B