Problems during Network Setup
WPS
Multiple APs detected is Displayed
Action
The message appears when multiple access points are
detected. Wait for a while, then configure the settings
again.
Failed to connect is Displayed
Check
The message appears when an error occurs. Check the
access point settings, then configure WPS settings again.
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
•
For the procedure to configure WPS settings of the machine, refer to "Wireless Setup Using WPS
(Wi-Fi Protected Setup)" in the printed manual: Getting Started.
•
When using an access point that does not support WPS, configure the settings by referring to "7
Set Up a Wireless Connection" in the printed manual: Getting Started.
PIN codes do not match is Displayed
Action
The message appears when setup is not completed within
10 minutes. Follow the procedure below to configure WPS
settings again.
1
Select PIN code method on the WPS screen, then press the OK button.
•
A new PIN code appears.
2
Set the new PIN code to the access point or computer.
•
For details on how to set PIN codes to the access point or computer, refer to the manual
supplied with your access point or contact its manufacturer.