8
Enter the access point name/network name (SSID),
then press the left FUNCTION button.
For details on how to enter characters, refer to "Character
Entry" on page 10.
•
Enter the same access point name/network name (SSID)
as that of the access point on the machine.
•
For details on how to check the access point name/network name (SSID), refer to the
manual supplied with the access point or contact its manufacturer.
•
Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive.
•
2-byte characters are not available for entering the access point name/network name
(SSID).
9
Make sure that the access point name/network name
(SSID) is correct, then press the OK button.
10
Select a security protocol for the access point, then
press the OK button.
•
Go to either of the following steps according to the
selected security protocol.
Go to
Disable
13.
WEP
Go to
Go to
WPA/WPA2
page 13.
•
When WEP 40 bit or WEP 128 bit is selected in AirPort Utility (AirPort Admin Utility),
select WEP.
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select WPA2-
PSK (AES).
•
When the access point is set to operate in IEEE802.11g and IEEE802.11n with TKIP set
as an encryption standard, communication is established using IEEE802.11g.
on page
.
on
•
When the access point is set to operate only in IEEE802.11n with TKIP set as an
encryption standard, a connection cannot be established. Change the encryption
standard to something other than TKIP or change the standard to something other than
IEEE802.11n, then configure wireless LAN settings again.
11-A
WEP
1
Select the WEP key number you want to use,
then press the OK button.
•
When using AirPort, select WEP key 1 in the
screen. Selecting other key numbers will disable
the connection between the machine and AirPort.
2
Press the right FUNCTION button.
3
Enter the network key, then press the left
FUNCTION button.
•
Enter upper and lower case letters of the alphabet
correctly. Letters are case sensitive.
4
Make sure that the network key is correct, then
press the OK button.
Go to
on page 13.
WPA/WPA2
(P.13)
Disable
(P.13)