Download Print this page

Ericsson HM200c/HM201c User Manual page 16

Ericsson inc. user's guide cable modem hm200c/hm201c

Advertisement

PipeRider® Cable Modem User's Guide
Installation: Ethernet for Macintosh
To connect the PipeRider cable modem to your Macintosh computer through an Ethernet port, your computer must
be equipped with a Network Interface Card (NIC) and configured for TCP/IP protocol.
Ethernet Setup
The following procedures are provided to assist you in verifying that your Ethernet port is configured for TCP/IP
protocol.
Select the Apple menu and then select Control Panels >> TCP/IP. The TCP/IP window will appear.
1.
In the Configure list, Using DHCP Server should be selected.
2.
Equipment Connections
Follow the steps below in the order given:
1.
Connect the coaxial cable between the
service provider's cable jack and the
cable connector on the back of the
cable modem. Be sure not to bend the
center wire on the connector. Hand
tighten both connectors.
2.
Connect the Ethernet cable between
the 10BT connector on the back of the
cable modem and the RJ45 connector
on your computer's Network Interface
Card (NIC).
3.
Plug the DIN connector of the power
supply cable into the Power connector
on the back of cable modem. Plug the
power supply into a surge protected
power source.
4.
When power is applied to the cable
modem, the modem will enter the
power-up diagnostics state to verify
the integrity of the hardware and
software. To learn more about the
states and operation of the PipeRider
cable modem,
click
here.
HM200c/HM201c

Advertisement

loading

This manual is also suitable for:

Piperider hm200cPiperider hm201c