Table of Contents
Advertisement
3.1.2
Wiring EDGE Connectors
It is recommended to follow the "Best practice" wiring procedure when
wiring the EDGE connectors.
The EDGE connector can be mounted by using a Tool Kit. The kit consists
of a wiring bracket-tool and an LSA+ inserter-tool. Figure 3 on page 5
shows how to mount the wiring bracket-tool on the rods in a subrack.
Figure 3
The EDGE connectors must be mounted as shown in Figure 4 on page 6.
The wiring bracket-tool ensures that the cables are long enough so that the
IP DSLAM can be dismounted by pulling it out. In case the wiring bracket-
tool is not used, it is important to ensure that the cables are long enough.
1/1531-HSD 101 41 Uen A 2004-01-30
Mounting the Wiring Bracket-Tool
Cabling
5
Hide quick links:
Advertisement
Table of Contents
