Onkyo HT-R791 Instruction Manual page 78

Appendix
The AV receiver can upconvert component video and
composite video sources for display on a TV connected to
the NDMI OUT. However, if the picture quality of the
source is poor, upconversion may make the picture worse
or disappear altogether.
In this case, try the following:
1
If the video source is connected to a component
video input, connect your TV to COMPONENT
VIDEO OUT.
If the video source is connected to a composite video
input, connect your TV to MONITOR OUT V.
2
On the main menu, select "Input/Output Assign",
and then select "Component Video Input"
(_ page 49).
If the video source is connected to COMPONENT
VIDEO IN, select the relevant input selector, and
assign it to "INI".
If the video source is connected to a composite video
input, select the relevant input selector, and assign it to
• To by-pass the upconversion, set the "Picture Mode" setting to
"Direct" (3 page
56).
En-78
©©