Onkyo HT-R791 Instruction Manual page 33

2
Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV receiver
is connected.
• Before plugging the Speaker setup microphone to perform
Automatic Speaker Setup, please make sure that all your
connected speakers and subwoofers produce sound.
Set the speaker setup microphone at the Main
Listening Position @, and connect it to the SETUP
MIC jack.
SETUP MIC jack
Speaker setup microphone
The speaker setting menu appears.
• The on-screen menus appear only on a TV that is connected
to HDMI OUT. If your TV is connected to other video
outputs, use the AV receiver's display when changing
settings.
3
When you've finished making the settings, press
ENTER.
2EQ: Auto Setup
Surround Back/Front High Surround Back
Perform the "Speaker Setup" according to your
speaker configuration:
- Powered Zone 2 (3 page 50)
- Surround Back/Front High (3 page 50)
4
Use i,/¥ to select "Audyssey Quick Start" or
"Audyssey 2EQ Full Calibration", and then press
ENTER.
5 Press ENTER.
Audyssey 2EQ® Room Correction and Speaker Setup
starts.
Test tones are played through each speaker as
Audyssey 2EQ Room Correction and Speaker Setup
runs. This process takes a few minutes. Please refrain
from talking during measurements and do not stand
between speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey 2EQ Room Correction and Speaker
Setup, unless you want to cancel the setup.
If you select "Audyssey Quick Start", you will go to
step 8.
6
Place the speaker setup microphone at the next
position, and then press ENTER.
Audyssey 2EQ performs more measurements. This
takes a few minutes.
7 When prompted, repeat step 6.
Turning On & Basic Operations
8 Use i,/¥ to select an option, and then press ENTER.
9
2EO: Auto Setup
- Review Speaker Configuration -
Subwoofer Yes
Front lOOHz _ _
Center 4OHz
_1Surround lOOHz
Front High None
Surround Back 120Hz _ _)
Surround Back Ch 2ch
Cancel
The options are:
Save:
Save the calculated settings and exit
Audyssey 2EQ Room Correction and Speaker
Setup.
Cancel:
Cancel Audyssey 2EQ Room Correction and
Speaker Setup.
• You can view' the calculated settings for the speaker
configuration, speaker distances, and speaker levels by
using _1/_,_
Use A/¥ to select a target, and use _/_ to change
the setting.
After the results of Audyssey 2EQ have been saved,
the menu will display the "Audyssey" (_ page 53),
"Dynamic EQ" (_ page 54), "Dynamic Volume"
(_ page 54) settings.
• When "Audyssey Quick Start" has been used for
measurement, "Audyssey" cannot be selected.
• These settings are applied to all input selectors.
10
Press
ENTER.
11
Disconnect the speaker setup microphone.
En-33
©©