Table of Contents
Advertisement
BEFORE
REQUESTING
SERVICE
;heck the following points once again.
Trouble
Co_n
_: NO power ...
• Check that the Power Plug is completely connected to an AC Outlet
gJ
• Check that the POWER Button is set to "ON".
_O No operation starts when operation
• Check the DEW Indicator. If it is displayed, the unit will not operate
=- buttons are pressed ...
(p=6, 7)
I"V programs can't be recorded ...
• Check the connections between VCR, external antenna and you:
TV.
• Check that the band selected is set to meet your antenna or cable
TV system. (p.13)
• Make sure that the record tab on the back of the cassette is stil;
(3
Z
8
Timer Recording can't be
)ertormed ...
There is no playback picture, or the
playback picture is noisy or contains
streaks ...
During special effects playback, the
)icture may contain some vertical
itter when using a "IV which has
Automatic Vertical Hold Control
Switch ...
If the top of your playback picture
waves back and forth excessively ...
intact. (p.21)
• Set the recording start/stop time correctly. (p.17-19)
• Make sure that the POWER Button is set to "OFF". (p.17)
• Timer Recording may not be performed or continued if a power
interruption of more than 2 minutes occurs before or during Time,
Recording, even if power resumes thereafter.
• Select the same channel on your"IV as that of the CH 3/4 Switch
on the VCR. (p.1)
• Set the VCR/TV Selector to "VCR". (p,1)
• Check that channel 3 or 4 of TV is properly adjusted.
• Adjust the TRACKING CONTROL slowly in either direction. (p.10)
• In that case, set the TV's Vertical Hold Control Switch to MANUAL
position and then adjust vertical hold control.
• Because the VCR playback signal is not as stable as an ofl-the-a_r
TV signal, you might experience the following symptom on your TV
screen: "Top of TV screen is bent or unstable when VCR is played
back." To solve this problem, turn the horizontal hold control on
your TV slowly to correct the wavy picture. If your TV does not
have the horizontal hold control or adjusting the control does not
help, please contact your local TV service center.
=_ RECORDER
cannot be remote
• Aim the Wireless Remote Control directly at the remote sensor on
_-=: controlled
the VCR.
OI-
""
_==
• Avoid all obstacles which may interfere with the signal path
LuO
=:u
• Replace or inspect the batteries. (p.7)
iYou can't view programs normally on
• Set the VCR/TV Selector to "TV". (p.1)
"l"V
...
Video cassette can't be inserted ...
Video cassette can't be removed ...
Video cassette ejects when the OTR
STANDBY, REC and PLAY Buttons
are pressed or the POWER Button is
)ressed OFF to set the Timer ...
03
n-
S
• insert the cassette with the window side up and the record tab
facing you.
• Check that the Power Plug is completely connected to an AC Outlet
• Check the cassette to be sure that the record tab on the back of
the cassette is still intact. (p.21)
- 23 -
Advertisement
Table of Contents
