Table of Contents
Advertisement
DESCRIPTION
OF CONTROL
(CONTINUED)
The following on-screen graphics will appear automatically
for a few seconds when one of the main function
buttons is pressed on the remote control or at the VCR. The channel currently tuned-in will be displayed
automatically for a few seconds when the power is first turned on, whenever the channel is changed, or when
the CHANNEL CALL Button is pressed thereafter.
STOP, EJECT, PLAY, REC, FF, REW, PAUSE, LINE, TIME, DATE, CHANNEL INDICATION, TIME COUNTER
TAPE SPEED, STANDBY SET (indicates the Standby O.T.R. mode is set), OTR (whenever StandbyOTR starts)
DEW*
I
(FuNcT=oN) 1
* When "DEW" appears on the "IV screen, the unit will not operate due to excessive
moisture within it. If this happens, let the VCR remain at room temperature, untit
this indicator disappears. If there is a cassette in the VCR, it will be ejected when
"DEW" appears.
Press the TIME
CALL Button to show or remove
the date
end time from the TV
screen.
TIME COUNTER
TAPE SPEED INDICATOR
1
COUNT
1:20,47
SLP
/
et
_MEMORy
1:_0,45
$PI
Press the COUNTER
CALL Button to show or remove the time counter and tape
speed display.
BLANK TAPE INDICATION
If a blank (unrecorded) section of tape is encountered while in the play mode, the TV screen will change to a
solid blue field. The screen will remain blue until a recorded signal is again detected.
LOAD THE BATTERIES
AS FOLLOWS:
Lift off the lid after pressing in
end up on the lid latch with
your thumb nail or other
narrow object
Install two batteries as
indicated inside the Battery
Compertnent.
Fit the lid's hinge piece into
the indent on the case, and
snap lid into place.
BATTERY
REPLACEMENT
CAUTION
• Do not mix old and new batteries. (Also never mix alkaline batteries with manganese batteries.)
-7-
Advertisement
Table of Contents
