Table of Contents
Advertisement
CONNECTIONS
TO MAKE
BEFORE
RECORDING
((
I
II
CABLE
CONNECTIONS
[2]
[BASIC
CABLE
CONNECTION,
WITH A (CABLE TO VCR) CONVERTER/DESCRAMBLER
BOX
If your cable service supplies you with a converter box, you can use the basic connection shown here If yd.,
cable system is different, refer to "ALTERNATE
CABLE CONNECTIONS"
on the following pages.
Back of TV
f,_
/"
TV Anne-n-n;- -_
Panel
CATV (cable)
Input
Cable TV
Converter Box
With this connection, you can record and view any channel including scrambled channels, However, channe _
selection must be made at the cable company converter box. Therefore, the VCR's remote channel control feature
cannot be used, unattended recording is limited to one channel at a time, and you cannot view another channe'
other than the one you are recording.
TO RECORD AND VIEW A SCRAMBLED/UNSCRAMBLED
CHANNEL
1. Set the VCR_rV selector located on the front of VCR to "VCR".
2. Set TV channel selector to the output channel of the VCR.
3
Set VCR channel selector to the output channel of the Ceble Converter Box. (e.g, CH 3).
4
Select channel to be recorded at the Cable Converter Box.
TO WATCH TV (WITH THE VCR OFF)
1, Set TV channel selector to the output channel of the Cable Converter Box,
2, Select the desired channel on cable converter channel selector.
Note to CATV system installeir:
This reminder is provided tO ca r the CATV system installer's atlention to Article 820-22 of the NEC in US;.
(and to the Canadian Electrical code in Canada) that provides guidelines for proper grounding and, in particu'a
specifies that the cable ground shall be connected to the grounding
system of the building, as close to th_
point O cable entry as pract ca!
Advertisement
Table of Contents
