DCS MO-24SS Use And Care Manual page 5

Safety /
door _
latches_
Unpackingand ExaminingYourOven
Remove: all packing materials from inside the oven
cavity; however, DO NOT REMOVE THE WAVEGUIDE
COVER, which is located on the right cavity wall. Read
enclosures and SAVE
_- or seals and
Hinges sealing surfaces
the Operation Manual.
Check the oven for any
damage, such as mis-
aligned or bent door,
damaged door seals
and sealing surfaces,
broken or loose door
hinges and latches and
dents inside the cavity or
on the door. If there is
any damage, do not
operate the oven and contact your dealer or DCS
AUTHORIZED SERVICER.
Choosing a Locationfor YourOven on
the counter
You will use the oven frequently so plan its location
for ease of use. It's wise, if possible, to have counter
space on at least one side of the oven. Allow at least 2
inches on the sides, top and at the rear of the oven for
air circulation.
Choosing a Locationfor YourOven if built-in
Your oven can be built into a cabinet or wall by itself
or above any DCS wall oven listed below using DCS's
Built-in Kits, either the MOSTK27 or the MOSTK30. The
MOSTK27 is for a 27" wall oven, while the MOSTK30
accommodates installation above 30" wall ovens.
TRiMKiTFRAME
ASSEMBLE
I
OVEROVENINSTALLATION
TOPOF
MICROWAVE
SHELF
WALL
OVEN CUTOUT
OVERWARMINGOVENINSTALLATION
2 n
(51MM)
WARMING
OVEN CUTOUT
The applicable wall ovens and warming ovens are
as follows:
OVENS - WO 127, WO 130, WOS127, WOS130
WARMING OVENS - WD 27, WD 30, WDS27, WDS30,
WDSI
Do not built=in above any other gas or electric
wall oven.
See Built-in Kit Installation Instructions for proper loca-
tion when building in above the specified wall ovens.
Carefully follow both the walt oven installation instruc-
tions and Built-in Kit instructions.
The opening in the walt or cabinet must be within the
following dimensions:
A HEIGHT : 17"
4- 1/16",
=0
B WIDTH : 24 3/4" + 1/16", -0
C DEPTH : minimum 20"