Cleaning And Care - DCS MO-24SS Use And Care Manual

Disconnect thepowercordbeforecleaning or leavethe door opento inactivate theover= duringcleaning.
Exterior
The outside surface is painted. Clean the outside with mild soap and
water; rinse and dry with a soft cloth. Do not use any type of house-
hold or abrasive cleaner.
Door
Wipe the window on both sides with a damp cloth to remove any
spills or spatters. Metal parts wilt be easier to maintain if wiped
frequently with a damp cloth. Avoid the use of spray and other harsh
cleaners as they may stain, streak or dull the door surface.
Touch Control Panel
Care should be taken in cleaning the touch control panel. If the
control panel becomes soiled, open the oven door before cleaning.
Wipe the panel with a cloth dampened slightly with water only. Dry
with a soft cloth. Do not scrub or use any sort of chemical cleaners.
Close door and touch STOP/CLEAR pad.
interior
Cleaning is easy because little heat is generated to the interior
surfaces; therefore, there is no baking and setting of spills or spat-
tering. To clean the interior surfaces, wipe with a soft cloth and warm
water. DO NOT USE ABRASIVE OR HARSH CLEANERS OR
SCOURING PADS. For heavier soil, use baking soda or a mild soap;
rinse thoroughly with hot water. NEVER SPRAY OVEN CLEANERS
DIRECTLY ONTO ANY PART OF THE OVEN.
Waveguide Cover
The waveguide cover is made from mica so requires special care.
Keep the waveguide cover clean to assure good oven performance.
Carefully wipe with a damp cloth any food spatters from the surface
of the cover immediately after they occur. Built-up splashes may
overheat and cause smoke or possibly catch fire. Do not remove the
waveguide cover.
Odor Removal
Occasionally, a cooking odor may remain in the oven. To remove,
combine 1 cup water, grated peel and juice of 1 lemon and several
whole cloves in a 2-cup glass measuring cup. Boil for several
minutes using 100% power. Allow to set in oven until cool. Wipe
interior with a soft cloth.
Turntable/Turntable Support
The turntable and turntable support can be removed for easy
cleaning. Wash them in mild, sudsy water; for stubborn stains use a
mild cleanser and non abrasive scouring sponge. They are also
dishwasher-proof. Use upper rack of dishwasher. The turntable
motor shaft is not sealed, so excess water or spills should be wiped
up immediately.
Exterior
Turntable
Turntable Support
27