Architect Series Custom Side Panels - KitchenAid KBLC36FMS02 Installation Manual

NOTE: When creating a panel with face detail, the offsets will be
hidden and must be accounted for in order to center the detail in
the top grille.
"
(1.3 cm)
min.
Center face
detail between
offsets
"
(9.5 mm)
min.
Door Panel – Routing Requirements
If the custom panels are thicker than
of the panels must be routed. If the standard handle is used, route
the entire handle side of both panels 3 " (8.25 cm) to allow for
finger clearance. Then route the hinge side of the refrigerator
panel 1" (2.54 cm). Route both sides of the freezer panel 1"
(2.54 cm).
Standard Handle – Top View
3 "
(8.25 cm)
min.
" (6.35 mm) max.
2" (5 cm)
min.
If an extended handle kit is used, route the handle side
(6.35 mm). All other routing dimensions would remain the same as
the standard handle. Make sure your product location will allow
doors with extended handles to be opened to 90 degrees. See
"Door Swing Dimensions."
For more information on ordering extended handles, see "Classic
Series Factory Panels and Kits."
NOTE: For both types of handles, route the top and bottom edges
of the refrigerator panel " (1.27 cm). Route the bottom of the
freezer panel " (1.27 cm).
"
(6.35 mm) max.
"
(6.35 mm) max.
" (6.35 mm), then all edges
Hinge Side
Door Door
Panel Panel
(2.54 cm)
"
Door Panel - Side View
Extended Handle - Top View
"
(6.35 mm)
Architect
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed and the end of a cabinet run. You
may choose an Inset, Flush, or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type of
installation you are planning.
NOTES:
The dimensions shown are actual product dimensions and
may not reflect the needed panel installation dimensions.
1"
The side panel should be a minimum of ½" (1.27 cm) thick
to avoid warping.
If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on the rear wall.
Refrigerator
24 "
(61.3 cm)
23 "
(60.3 cm)
(6.35 mm)
max.
" (1.3 cm)
min.
1"
(2.54 cm)
max
Door
Panel
® Series Custom Side Panels
23 "
(59.7 cm)
"
Hinge Side
Door
Panel
1"
(2.54 cm)
13