Craftsman 113.29461 Owner's Manual page 4

unpacking and preassembly
2. Mounting Your Saw on a Workbench
Mount on a Craftsman Power Tool Base or a sturdy, flat
bench, in such a position that the elevation crank will be
free to rotate,
WARNING: Do not connect the power cord to
a source of power. This cord must remain un-
plugged whenever you are working on the saw.
3. Installing the Elevation Crank and Swivel Latch-Pin
Knob (Figure 2)
a. Install the elevation crank and tighten the setscrew
on the flat portion of the shaft.
Figure 2 ,_
SWIVEL LATCH-PIf CARRIAGE
KNOB -- STOP
SCREW
SHIPPING
BLOCK
CARRIAGE
ASSEMBLY
ELEVATION C
Figure 3
4. Installing the Motor and Carriage Assembly on the
Radial Arm (Figures 2 and 3)
a. Rotate tbe elevation crank clockwise several turns
and remove the shipping block from between the
carriage and the radial arrn.
b. Remove the carriage stop screw. Iockwasher and
warning tag.
c. Holding the carriage assembly with both hands,
carefully start and slide the carriage onto the
radial-arm tracks. The assembly must be held parallel
with the arm so that all four of the assembly bearings
will smoothly slide onto the two arm tracks, thus
preventing any excessive strain on the bearings and
tracks.
d. Reinstall the carriage stop screw and Iockwasher.
WARNING: Unless this is done carriage can rol!
off the arm.
e. Remove the two shipping screws from bottom of
motor, and discard. Leaving these in would limit
depth of cut.
f. Check the cord in the arm cord clip to make sure
there is 30 inches length of cord between this clip and
the cord clip on the yoke.
g. Install the swivel latch pin knob.
ARM CORE) CLIP
View above
shows R-H
indicator
installed.
Figure 4
5. Installing the Rip Scale Indicators (Figure 4)
a. Remove the carriage lock knob, then remove the
right-hand carriage cover.
b. Attach a rip-scale indicator to the top of the carriage
cover, using one twin nut and two 6 32x7/16-inch
pan-head screws. Tighten the screws lightly -- the
indicator will be adjusted, later
c, Reinstall the carriage cover and knob.
Similarly attach the remaining rip-scale indicator to
left-hand carriage cover, then reinstall this cover
Note that there is no knob on the left side;
only
[he
cever need be removed and reinstalled.