Advertisement
Available languages
Available languages
C6"o'W THER
OP"- T'O"
'
The lithium-ion battery pack can be used in temperatures
down to -4*E Put the battery pack on a tool and us_ the
tool in a light duty application. After about a minute, the
pack willhave warmed up and begln operating normally.
ENERGIZING- BATTERY CHARGER
-
See Rgure 3, page tL
- . :
Refer to vehicle owner's manual for location of clga-"
retts lighter receptacle or "power point'_By holdingthe
connector firmly, place connector into a cigarette lighter
i
. ..
• receptacle or power point to energize 'batte_ charger;red
POWER LED will come on.
CAUTION:
If the 12 V adaptor does not fit firmly
into the olgaratte lighter receptacle or powerpoint,
the receptacle may not be sLtltable for use with the
.charger. A poor connection at tf_ebase of the 12 V
.adaptorcguld
lead to electrical problems In the
vehicle outside of the protection offered by the
vehicle or charger's fuse.
• o
•
_
+
A_
WARNING;
When servicing, we only Idee_cal
Craftsman replacement parts, Use of any other pert
may create a hazard or cause product damage.
_k
WARNING:
Always wear ey'eprotection marked to
_;omply with ANSI 7_87.1.Failure to do so could result
in objects being thrown into your' eyes res(Jltingin
• possible seduus injury.
_IL
W,_RNING: To avoid serious personalinjury, always
rernovet_e battery pack from the tool when cleanin_
or performingany maLntenance,
- -
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plaslics are susceptible to damage from vadous types of
commercial solvents and may be damaged by their use.
Use clean clothe to remove dirt, dust, oil, grease, etc,
_k
WARNING: Do not at any time let brake fluids,
gasolice, petroleum-based products, penetrat_g
oils, etc., come In contact with plastic parts,
Chemicals can damage, weaken or destroy plastic
which may result In serious personalInjury.
CHANGING
FUSE
See Figure 4, page it.
The 12 V adaptor contains a 250 V 8 Amp fuse to protect
the adaptor and charger from unexpected power surges.
To replace the fuse:
• Unscrew the fuse cap on the top of the 12 V adaptor.
• R_p[ace old fuse with new one. If spdng comes out, be
sure to reinsertlt before replacing new fuse.
•
Thread fuse cap back onto adaptor. Tighten secUrely.
BATTERIES
This charger will accept all Craftsman EX and DieHard
192. Volt battery packs. Length of servk_e from each
charging willdepend on the type of work you are doing,
'
Battles have been dDsigced to provide maximum treuble-
.'tree life. However,I_e all bsttedas, they will eventually
wear out. De p_t disassemblebattery packand attempt to
replacethe batteries, Handlingof these batteries, especbUy
when wearing ringsand Jewelry,could result In a serious
bL_-n.
To obtain _e lor_gest possibtebattery'life, we suggest the
following:
For Ilthlum-ion batteries;
.1 Remove the battery pack from the charger once it is"
_ _ulJycharged _,ndready for use..
For batte W pack storage longer than 30 da_s:
• Store the battery pack where the temperaturaIs below
80=F and away from moisture.
• Store b_tery packs in a 30%-50% charged condition.
• Every six months of storage, charge the pa_ as no'rm_.
For nickel-cadmium battei'ies:
-.
-
• Remove the battery pack from the charge_"or_ce I t is
fully charged and read7 for use,
For battery pack storage longer than 30 days;
. °.
• Store the battery pack wl_re the temperature !s below"
BI_I",
.
.
• Slore battery packs in a "discharged" condRio_l.. " "
_i
WARNING:
Upon removal, cover the batteiy_k_
terminalswith heavy-duty adhesive tape, Do nbt-.,
attempt to destroy or dlseesemble battery l_ack.'-_"
• or remove any of its components. Lithhlm-ion'eed
nickel-cadmium batteries
must be rec_,cled
or dla-
posed of properly_ Nso, never touch both terminals
with metal objects and/or body parts as short circuit
may result. Keep away from children. Failureto
comply w_ these warnings could result In fire and/
or ear[cue Injury.
7 - English'
Advertisement
