Craftsman 917.249870 Owner's Manual page 6

CONTAINER ASSEMBLY (See Fig. 3)
• Place bottom half inside of top half, as shown.
• Place one foot inside bottom half and lifttop half to meet
bottom half.
Press halves tightly together while liftingtop to lock into
place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED
EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET.
• Repeat for other containers.
CONTAINER
BOTTOM
HALF
TOP HALF
CONTAINER
BOTTOM
HALF
PRESS TOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
LOCKING
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
J
J
FIG. 3
CONTAINER MOUNTING
(See Fig. 4)
• Install one container to left side first with warning to
outside of unit. Install another container to center
position and one in right position.
NOTE: Right container should always overlap left container
at center supports.
• Close cover and lock latch handles over center support
tubes.
COVER LATCH
HANDLES
CONTAINER
WARNING
CENTER (
SUPPORT
TUBES
CONTAINER
HANDLE
CONTAINER
WARNING
FIG. 4
6