Craftsman 113.228162 Owner's Manual page 6

assembly
1. UnpaCk all the part_ of your wood lathe and lay them
0ut in your work area so they can be recognized easily.
Checkall partswith the parts table and be careful not to
" i lose any parts during assembly.
2_ Begin by placing thetUbe assembly on your workbench
as shown. Always keep the squa red key section straig ht
down.
TUBE ASSEMBLY
l
!
/
SQUARED KEY SECTION
. 3. Slide the headstock onto the tube until it stops against
the squared key section, Insert locking setscrew and
tighten with hex wrench.
SPINDLE PULLEY
t
TUBE
HEADSTOCK-TUBE LOCKING
SETSCREW tN REAR OF
HEADSTOCK X
HEADSTOCK SPINDLE
_ED KEY
SECTION
4. Slide the clamp support onto the middle of the tube.
Assemble lock handle as shown.
6. Set large tool rest in tool rest holder and install locking
handle as shown.
REST
Slide tailstock assembly onto the tube and install
tailstock ram spindle lock handle. Notice location of
keyed way i_ spindle with studnut,
TAILSTOCK RAM SPINDLE
KEYED
HEADSTOCK END
_
STUDNUT
HANDLE
/ LOCKNUT
TAILSTOCK ASSEMBLY
8. On the backside of the tailstock asse ruble the locking
devices as shown.
5. Attach the tool rest bolder to the clamp supporl as
shown,
HEX BOLT _.__ TOOL REST
HOLDER
sPACE"
HANDLE _% : "_'_-2
LAT WASHER @"a
"--..
_ THREADED HOLE
_ I _ IN CLAMP SUPPORT
CLAMP SUPPORT
TAILSTOCK ASSEMBLY LOCKNUT_
_._... ,.,....%% ,._ HANDLE
lllill t s.o2?0CK V---STUONOT
t!!. IIYI f- -----J
ND
BRASS SCREW @"_'-LOCKING NUT
9. Instal] the rear foot onto the tube as shown and tighten
rear foot to,cking screw, Foot wilt wedge into ptace as
screw is tightened. This may take several attempts,
HEADSTOCK END
I REAR FOOT
TUBE ASSEMBLY