Repair Parts; Motor Diagram; Motor Connections - Craftsman 113.228162 Owner's Manual

rep=ir pans
CRAFTSMAN "_ 2-iNCH WOOD LATHE, MODEL 113,228162
NOTE:
ANY ATTEMPT TO REPAIR THIS MOTOR
MAY CREATE A HAZARD UNLESS
REPAIR IS DONE BY QUAUFIED
SERVICE TECHNICIAN.
REPAIR SERVICE IS AVAILABLE
AT YOUR NEAREST SEARS STORE.
t 2
Figure I
MOTOR PART NO. 70055
Key Part
No. No. Description
I 6030(_ Screw. 8-32 x 3/8, Thread
Cutting, Slotted, Serrated
Hd.
2 64088 Cover. Terminal
3 64258 Cord with Plug
MOTOR CONNECTIONS
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE PROCEEDING.
1. Open motor connector box cover located on left end of
motor (viewed from rear of saw) using a flat blade
screwdriver,
2. Remove GREEN SCREW and iockwasher and insert
screw through round metal terminal on _he end of the
GREEN wire of power cord with leckvvasher between
terminal and motor frame. {See iHus,)
3. ReinsertGREEN SCREW in the threaded hole Tighten
securely
4. Insert terminal end of WHITE wire on spade _erminat
r'narked T4 on the motor Push terminal firmly until
seated,
5 Insert terminai end of BLACK wire on spade terminal
marked T1 on the motor. Push terminal firmly until
seated.
6. Close motor connector box being surethat power cord is
seated in the largest strain retief groove, and tighten box
cover screws.
GREEN
INTERNAL
LOCKWASHER
BLACK WIRE TO
TERMINAL TI
m
TERMINAL
GREEN WIRE
-TO GREEN SCREW
STRAIN RELIEF
WIRE TO
TERMINAL T4
,\
33