Craftsman 113.228162 Owner's Manual page 8

With the end of the la{he spindle: Tighten the pulley
screw against the flat:of theshaft
12, P|ace the motor pulley on the motor shaft so that the
small diameter is approximately 1/16 away from the
motor. Tighten the setscrew with a 5/32" setscrew
wrench securety against the flat spot on the motor
shaft.
t3. Place the belt on the pulleys and slide the motor toward
the rear of workbench until all the slack is removed from
the belt. NOTE: 1/2 inch deflection of belt under
moderate pressure applied between the two pulleys is
adequate tension. Tighten only two of the motor
mounting bolts.
14. Place a straightedge such as a piece of wood, metal or
framing square across the pulleys to see if they are in
line with each other, tf they are, tighten the other two
motor mounting bolts. If they are not in line, loosen the
two motor bolts and move the motor sideways .
tighten the boJts.
15. Find four pan head wood screws t/2" long from a mong
the loose parts
16, Attach the belt guard plate to the bench with the two
screws. Make sure the plate is PARALLEL to the belt.
17. Plug motor cord into outlet o n back of switch box. DO
NOT pJ4ug motor cord into power source outlet
18. Position the twocordsasshown andclamp themtothe
table with two cable clamps and 1/2" wood screws
from the loose parts bag.
t9. Coil up the stack in the cord and tie it with a piece of tape
if necessary.
CABLE CLAMPS
MOTOR CORD