On-Off Switch - Craftsman 113.228162 Owner's Manual

assemblly
WARNING: OONT CONNECT POWER COROTO
ON-OFF SWITCH
The On-Off Switch has a locking feature. THIS FEATURE
IS INTENDED TO PREVENT UNAUTHORIZED AND
POSSIBLE =HAZARDOUS USE BY CHILDREN AND
OTHERS.
1, Insert key into switch.
NOTE:
Key is made of yellow _lastic. _1;
K E Y
(YELtOW _AST It1
2. To turn Lathe ON,.. INSERT finger under switch lever
and pull END of switch out.
J
KEY
3.: To turn Lathe OFF... PUSH lever in,
Never leave the Lathe unattended until it has come to a
complete stop ant you have removed the switch key.
Do net cycle the motor switch on and off rapidly, as
this may cause the faceplate or sanding disc to loosen.
In the event this should ever occur, stand clear of the
face plate or sanding d_sc until it has come to a complete
stop, ,. retignten it.
4. To lock switch in OFF position . . . HOLD switch IN
with one hand, REMOVE key with other hand.
WARNING: FOR YOUR OWN SAFETY, AL-
WAYS LOCK THE SWITCH "OFF". WHEN
LATHE IS NOT IN USE ... REMOVE KEY AND
KEEP IT IN A SAFE PLACE . ALSO. IN
THE EVENT OF A POWER FAI'LURE (ALL'OF
YOUR LIGHTS GO OUT) TURN SWITCH OFF,,.
LOCK IT AND REMOVE THE KEY. THiS WILL
PREVENT THE LATHE FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK ON.
Io
_OLD
I
I
\
\
PULL