Epson Perfection V700 Photo User Manual page 5

3. Use a soft cloth to wipe the transparency unit window and
the document table before placing your film or slides.
To place film or slides for scanning, see the sections below.
Placing Film in the Holder
Placing 35mm Film Strips
1. Remove the film strip cover(s) on the film holder.
2. Slide up to four film strips all the way into the film holder
with the shiny base side facing down. Your images and any
wording on the film strips should appear backwards on the
side that faces up, as shown by the illustration on the film
holder.
Note: Hold the edge of the film gently or use gloves to touch the
film; otherwise you may damage the film. Make sure the white
stickers on the back of the film holder and the areas around them
are not scratched, dusty, or covered in any way. If the areas are
obscured, the scanner may have trouble recognizing your film in
Full Auto Mode. Do not cover any of the tiny holes in the film
holder or the scanner may have trouble recognizing which film
holder you are using.
Epson Perfection V700 Photo/V750 Pro
3. Place the cover(s) over the film and press them down until
they click. Then press down on all the edges of the covers to
secure them.
4. Place the film holder on the document table so that it is
aligned with the upper right corner and the pins are seated
in the holes on the scanner.
5. Make sure you removed the document mat. See "Removing
the Document Mat" on page 4.
6. Close the scanner cover.
When you are finished scanning film, be sure to replace the
document mat before scanning documents or photos. See
"Replacing the Document Mat" on page 9.
Placing Medium Format Film
1. Open the cover on the medium format film holder.
2. Slide up to two medium format film images into the film
holder with the shiny base side facing down. Your images
and any wording on the film should appear backwards on
12/05 Epson Perfection V700 Photo/V750 Pro - 5