Drill Speeds; Recommended Drill Press Speeds - Craftsman 152.229010 Instruction Manual

Figure 10-3 Figure 10-4
G
20 o 100 0 10° 200 300
5,
6,
The tame can be tilted right or Ueftby Uoosening the
tame Uocking bout (U),then removing the tame align-
ment pin (F), See Figure 10-3,
The tame can now be tilted to the desired angUe,
The tame Uocking bout then must be tightened,
7,
8,
H
A tilt scaUe (G) is provided on the tame bracket cast-
ing to indicate the degree of tilt, A witness Hne (H) is
provided on the tame to align with the tilt scaUe,
See Figure 10-4,
NOTE: When the tame is returned to the UeveU
position, repUace the tame alignment pin, This will
position the table surface 90 degrees to the spindle,
The table locking bolt then must be tightened,
DRILL SPEEDS
MAKE CERTAIN the drill press is disconnected from the power source,
Sixteen drill speeds (215, 310,340, 450, 490, 510, 600, 675,735, 750, 1200, 1380, 1500, 1850, 2035 and 2720
RPM) are available with your drill press, See Figure 11-1 to select the correct spindle speed for your operation,
This diagram can also be found on the inside of the belt cover of the drill press,
Figure 11-1
Recommended Dri|| Press Speeds
s ,o !so 00d IB0,d ,°0d I 0,y,0 I B 0°, I..mIst001
Twist DrillBits
1/1B"=3/1B"
1t4"- 3/8"
7/1B"=5/8"
11116" =1"
Brad Peint B its
1/8"- 1/4"
3/8"
1/2"
5/8"
3/4"o7/8"
1 _
Ferstner Bits
1/4"=5/8"
3/4"=1"
1ol/8"=1ol/4"
1o3/8" = 2"
2720 2720 2720 2728 2720 2720
2728 1500 2835 !200 2835 750
1580 750 1500 758 1500 BOO
750 5!B NR 340 750 340
1850 1208 1500 N£ NR NR
1850 750 1500 NR NR NR
1850 758 750 NR NR NR
1850 518 750 NR BR NR
1280 215 510 NR NR NR
750 215 215 NR NR NB
2720 BOB 215 NR NR NR
1580 510 215 NR NR NR
750 215 215 N£ NR NR
510 215 NR NR NR NR
NR = NOT R6COMMEN#E#
6P|H6LE PULLEY CENTE6 PULLEY _OTOR PULLEY
600
_45
19