Craftsman 152.229010 Instruction Manual page 13

Figure 4-5 Figure 4-7
Q
/
C_
M
5, Hace the clamp plate (L) over the tame extension
support and attach it with two threaded knobs (M),
8, Hace tame extension (Q) into tame extension sup-
port, See Figure 4-7,
Figure 4-6
J
/
Figure 4-8
/,
R y
N
6,
7,
AssemMe the threaded end of the tame rotation
lock handle (N) into hole (0) in the front, right side-
of the tame support, Do not completely tight handle
at this time, Note: The tame rotation lock handle is
the smaller of the two lock handles, See Figure 4-6
Insert the tame (J) into the mounting hole (P) tame
support, Rotate the tame to desired position and
tighten tame rotation locking handle,
See Figure 4-6,
9,
Assemble the threaded knob (R) into the weld nut
(S) on the table extension support, See Figure 4-8,
13