Advertisement
Available languages
Available languages
4.
Remove the regulator.
5.
Apply pipe sealant tape to the
nipple on the standpipe.
NOTE: Arrow indicates flow of air.
Make sure it is pointing in the direction
of air flow.
6.
Assemble the regulator and orient
7.
as shown.
8.
Regulator
Reapply pipe sealant to gauges
and quick connect.
Reassemble outlet pressure
gauge and quick connect. Orient
gauges to read correctly. Tighten
connect with wrench.
Before you store the air compressor,
make sure you do the following:
1.
Review the Maintenance section
on the preceding pages and per-
form scheduled maintenance as
necessary.
2.
Drain water from air tank. See To
Drain Tank under Maintenance.
_
Water will
condense
in the
air tank. If not drained, water will
corrode and weaken the air tank
causing a risk of air tank rupture.
3.
Protect the electrical cord and
air hose from damage (such as
being stepped on or run over).
Wind them loosely around the
compressor handle.
4.
Store the air compressor in a
clean and dry location.
23- ENG
Advertisement
