Advertisement
Available languages
Available languages
A.
Are both tabs inside the han-
dle?
B.
Does each clip pass through
both the saddle and handle?
TO ASSEMBLE WHEELS
_lt
will be necessary
__
to brace or support
one side of the air compressor
when
installing the wheels because the
compressor
will have a tendency
to
tip.
1.
Attach wheels with shoulder bolts
and nuts as shown.
2.
Tighten securely. NOTE: The air
compressor will sit level if the
wheels are properly installed.
_The
wheels and
--
handle do not
provide adequate
clearance,
stability
or support for pulling the unit up and
down stairs or steps. The unit must
be lifted, or pushed up a ramp.
ASSEMBLE
RUBBER
FEET
1.
Attach rubber feet with the
screws, washers and nuts pro-
vided as shown in figure below.
2.
Tighten securely.
Nut
Wheel
OiL FOR PUMP
_Risk
of Property
Damage. This com-
pressor was shipped with oil in the
pump crankcase. Check oil before
operating air compressor, see Check
Oil under Maintenance.
LOCATION
OF THE AiR
COMPRESSOR
•
Locate the air compressor in a
clean, dry, and well ventilated
area.
Place on a solid surface to prevent
rocking or tipping.
The air compressor should be
located at least 12" (30.5 cm)
away from the wall or other
obstructions
that will interfere with
the flow of air.
The air filter must be kept clear of
obstructions which could reduce
air flow to the air compressor.
The air compressor requires fresh
air flow for proper cooling. DO
NOT ALLOW THE COMPRESSOR
TO GET WET.
11- ENG
Advertisement
