Control Knobs; Burner Assembly - GE J2S968 Owner's Manual

Careand cleaning of the range. . CEAppliancescom
Be sure all controls are off and all surfaces are cool before cleaning any part of the range.
- Ifyourrangeisremovedforcleaning, servicingoranyreason, besuretheanti-tip
device is reengaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.
How to Remove Packaging Tape
To assure no damage is done to the finish
of the product, the safest way to remove
the adhesive left ti'om packaging tape
and cooktop labels on new appliances
is an application of a household liquid
dishwashing detergent, mineral
oil or
cooking oil.
Apply _dth a soft clofl_ and allow to soak.
Wipe dry and then apply an appliance
polish m thoroughly clean and protect
the surfi_ce.
NOTE: Theadhesive must be removed from aft
parts. It cannot be removed if it is baked on.
Control Knobs
Thecontrol knobs may be removed for easier
cleaning.
gefi_re removing the knobs fi_r
cleaning, please note that the knobs are
in the OFFposition. When replacing the
knobs, check the OFF position to insm'e
proper pla cement.
X._sh the knobs in soap and water or a
vinegar and hot water solution but do
not soak.
rcap
J(_) Burner head
CAUTION:DO NOT OPERATE THE
BURNER WlTHOUTALL BURNER
PARTSIN PLACE.
Burner Assembly
The 1)urner assemblies should be washed
regularly and, of com_e, after spilh)ve_.
Turnall controls off before removing burner parts.
The 1)urner grates, 1)urner
heads and
btlYneI" caps can
be
i'eilloved _'k)i" easv
cleaning.
The electrode (ff the spark igniter is
eN)osed beyond the stm'i_ce _ffthe
burner base. X&]mn cleaning the cooktop,
be careflfl not to snag the electrode of
the spark igniter with your cleaning
cloth. Damage to the igniter could occm:
Toavoid snagging a cloth on the spark
igniter, leave the burner heads in place
when cleaning the cooktop.
Be carefld not to push in any cooktop
controls while cleaning the cooktop.
A slight electrical shock might result
which could cause um to knock over
hot cookware.
X._hsh btm_er parts with an allimq)ose
non-abi}lsive cleaner
}lnd W}llIll
wateI:
Soak stubborn soil. Dry them with a
cloth---do not reassemble while wet.
To reassemble, replace the burner head
fi_t, then the burner cap and finally the
burner grate. Be sure the
pins
in the
burner head are properly located in the
btlrner base holes.