Weider Platinum XP800 User Manual page 10

15. Pull the excess Upper Wire Harness (71) out of
the Upright (2). Insert the connector on the
Console (67) intothe socket on the Upper Wire
Harness. The connector should slide easily into
the socket and snap into place. If the connector
does not slide easily and snap intoplace, turnthe
connector over and then insert it.
Make sure that the connector and wires appear
as shown in the inset drawing. IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
Push the excess Upper Wire Harness (71) into
the Upright (2).
Attach the Console (67) to the Upright (2) with
four M4 x 70ram Screws (114).
16. Attach a Large Pulley (14) and the Pulley Plate
(68) to the Upright (2) with an M12 x 62mm
Button Bolt (81) and an M12 Nylon Locknut (43).
Do not tighten the Locknut yet.
17. Pull the upper cable (A), which is attached inside
of the Mech Frame (not shown), up between the
Updght (2) and the Pulley Plate (68).
Attach another Large Pulley (14) to the Upright (2)
and Pulley Plate (68) with an M12 x 62mm Button
Bolt (81) and an M12 Nylon Locknut (43). Make
sure that the upper cable (A) is between the
two Pulleys.
Hold the 38mm Spacer (90) inside the loop of the
upper cable (A), and between the Upright (2) and
the Pulley Plate (68). Attach the Spacer with an
M1O x 58mm Button Screw (42). Make sure the
ends of the cable do not wrap around each
other below the Spacer and the Large Pulleys
(14) used in steps 16 and 17 (refer to the
CABLE DIAGRAM on page 20).
Tighten the M12 Nylon Locknuts (43) used in
steps 16 and 17.
18. Attach a Small Guide Spacer (18), a Large Guide
Spacer (17), and two Bar Guides (15) to the
Upright (2) with an M10 x 152mm Bolt (86).
Pull the upper cable (A) up between the Bar
Guides (15). Press the metal cover on the cable
into the groove in the BlockSpacer (16). Attach a
Small Guide Spacer (18), the Block Spacer, the
two Bar Guides (15), an M10 Thick Washer (54),
and the two Tethers (70) to the Upright (2) with
another M10 x 152mm Bolt (86). Do not tighten
the Bolt yet.
15
16
17
18
114
f
114
68
14
2
81
_43
81
17 ._
18 86
Metal
54
7O
18 16 Groove
43
86
t0