Scan To E-Mail Setup - Sharp FO-NS2 Operation Manual

5. Scan to E-mail Setup

To use the Scan to E-mail function, the subject and sender information
(name and e-mail address) that appear when an image is sent to an e-
mail recipient must be entered, and the file format for the scanned image
must be selected. (Note: The file format set in this procedure does not
apply to Scan to E-mail using a Rapid Key or Speed Dial number.)
♦
The preset subject is "Scanned image from FO-DCXXX" (where
"XXX" is "500" or "600"), and the preset file format is "TIFF/G4".
♦
You can enter a different sender name and select a different file
format at the time of transmission. The subject can only be changed
using the following procedure.
Important:
To use Scan to E-mail, sender information must be set using the
following procedure, or using the Web page as explained on page 11,
even if a sender is manually entered at the time of transmission.
Note: In the event that your e-mail server is unable to deliver a Scan
to E-mail transmission to a specified e-mail address, your server will
send notification to the sender's e-mail address that you enter in the
following procedure or at the time of transmission.
1
MENU
Press
•
Make sure that NETWORK
SETTING is selected in the display.
2
START/
Press
ENTER
until SCAN TO E-MAIL SET-UP is
selected.
3
START/
Press
ENTER
4
START/
Press
ENTER
16
and then
and then or
.
.
Display:
.
MENU MODE
5:PROGRAM/GROUP MODE
6:SERIAL POLLING MODE
7:MEMORY POLL MODE
8:NETWORK SETTING
NETWORK SETTING
1:NETWORK CONFIG SET
2:SCAN TO E-MAIL SET-UP
3:NETWORK SETTING LIST
SCAN TO E-MAIL SET-UP
1:E-MAIL SUBJECT
2:E-MAIL SENDER
3:FILE FORMAT