Sending An Image Using A Speed Dial Number - Sharp FO-NS2 Operation Manual

Sending an image using a Speed Dial number

Use this procedure to scan a document and send the image to an E-
mail, FTP, or Desktop destination that has been stored in a Speed Dial
number.
Important: To use this procedure, the setup procedures outlined on
page 4 must be completed. In the case of Scan to E-mail, this includes
setting a default sender as explained in the procedure beginning on
page 16 of this manual.
♦
If you are sending the image to an e-mail destination and need to
change the subject, use the procedure on page 16.
1
Load the document(s).
•
SEND READY will appear in the
display.
RESOLUTION
•
Press
set the resolution and contrast if
needed. The default resolution is
FINE. Note that STANDARD and
SUPER FINE are primarily for
faxing and are not recommended
for scanning.
SPEED DIAL
2
Press
the numeric keys.
•
If you enter less than 3 digits for the Speed Dial number, press
START/
to complete the entry.
ENTER
•
Check the display to make sure the destination shown is correct (if
not, press
Sending an Image Using a Rapid Key or Speed Dial Number
CONTRAST
and/or
and then enter the Speed Dial number by pressing
STOP
and repeat Step 2).
to
23