Power Source; Listening To The Ipod - Sharp DK-AP2 Quick Start Manual

Power source

H H H H H Using with the AC/DC adaptor
1
Plug the AC power lead into the AC/DC adaptor.
2
Plug the AC/DC adaptor cable into the DC Input socket on
the unit.
3
Plug the AC power lead into a wall socket and switch on
the power supply. The STAND-BY indicator turns red and
when the power is on, the POWER indicator turns blue.
AC/DC Adaptor Cable
DC INPUT socket
(DC 6V)
AC Power Lead
AC/DC Adaptor
Wall Socket
(AC 110 - 240 V, 50/60 Hz)
H H H H H Using with the batteries
1
Disconnect the AC/DC adaptor, and open the battery
compartment.
2
Insert 4 "AA" size batteries (UM-3, R6 or similar) into the
battery compartment.
3
Close the battery compartment.
4
The STAND-BY indicator will turn red.
Remove the batteries if the unit is not to be used for long
period of time to prevent battery leakage which may cause
potential damage.
When using batteries, the brightness of all illumination light
(indicators) is reduce compared to using AC/DC adaptor.
Turn on your system
Press the ON/STAND-BY button to turn the power on. The
POWER indicator turns blue to indicate power on.
VIDEO
OUT
DC IN 6V
AUX IN
VIDEO
DC IN 6V OUT
AUX IN
E SOUND
STAND-BY

Listening to the iPod

To insert iPod adaptor
H H H H H
1
Insert the iPod adaptor into unit and connect your
iPod.
iPod (bottom)
Dock connector
iPod adaptor
iPod dock
iPod connector
To remove iPod adaptor
H H H H H
Insert the tip of a screwdriver ("–" type, small) into the iPod
adaptor hole as shown and lift upward to remove.
iPod playback
H H H H H
Note:
Do not connect the Audio cable to AUX IN socket during iPod
playback. Otherwise, sound from the iPod will not be heard.
1
Press the ON/STAND-BY button to turn the power on.
2
Insert iPod unit in iPod dock of main unit.
Press the 0 0 0 0 0 / 6 6 6 6 6 button if the iPod unit is in pause mode
to start playback.
iPod adaptor
To disconnect iPod
H H H H H
Simply remove the iPod from the iPod dock. It is safe to do
so even during playback.
iPod
iPod