Belt Tracking - Delta 31-396 Instruction Manual

ANGLE OF BELT SANDER
DISCONNECT MACHINE FROM POWER
SOURCE.
1. The belt sander can be tilted from 0 degrees to the
table up to 90 degrees to the table.
2. Move the table to the front of the machine. Grasp the
tilting handle (C) Fig. 39.
GRASP THE TILTING HANDLE FIRMLY
WHEN REPOSITIONING THE BELT
SANDER.
3. Position the detent pin (A), as shown in Fig. 41.
4. Loosen ratchet handle (B) Fig. 40.
5. Push down on the handle (C) Fig. 39 until the pointer
(D) Fig. 41 lines up with the desired angle on the scale
(E).
6. Tighten ratchet handle (B) Fig. 41.
NOTE: THE DETENT LOCK PIN (A) FIG. 40 ALLOWS
FOR QUICK ADJUSTMENTS TO 0 DEGREES, 45
DEGREES, AND 90 DEGREES TO THE TABLE.

BELT TRACKING

DISCONNECT MACHINE FROM POWER
SOURCE.
1. Loosen nut (A) Fig. 42.
2. Turn nut (B) Fig. 42, clockwise or counter clockwise to
adjust belt tracking.
3. When belt is tracking properly, retighten nut (A) Fig. 42.
C
A
E
D
A
17
Fig. 39
Fig. 40
B
Fig. 41
A
Fig. 42
B
B