Specifications; Troubleshooting - Sharp Plasmacluster IG-A10EU Operation Manual

SPECIFICATIONS

Model
Power supply
Power consumption (W)
Airfl ow volume (m 3 /hour)
Applicable fl oor surface area (m 2 )*
Power cord (m)
Outer dimensions (mm)
Weight (kg)
*The target fl oor surface area for which an emitted airborne ion density of about 25,000 ions/cm
be measured at a point near the center of the room (at a height of about 1.2 m from the fl oor), during
operation at the HIGH mode when the main unit is placed near a wall.
• The number of ions will vary according to the room conditions and the main unit operation mode.

TROUBLESHOOTING

Before calling for service, please review the TROUBLESHOOTING chart below,since the problem may
not be Plasmacluster Ion Generator malfunctions.
Problem
The Plasmacluster Ion Generator
does not work.
fl ashing (blue)
fl ashing (blue)
The discharged air has odor.
A clicking or ticking sound comes
from the unit while operating the
Plasmacluster Ion Generator.
(High)
(High)
Make sure to put in the plug.
fl ashing faster
(red)
fl ashing (red)
fl ashing (blue)
The Plasmacluster Ion Generator releases a
220-240V, 50/60Hz
14.0
102
140 160
WHAT TO DO
Approx. 2 years and 2 months (approx. 19,000
hours) has been passed.
Replace with a new Plasmacluster Ion
Generating Unit. See page E-6,7.
Plasmacluster Ions are not released.
Press the Operation button and restart.
If all lights keep fl ashing, replace with new
Plasmacluster Ion Generating Unit. See page E-6,7.
Dust may block the fi lter, clean the fi lter.
•
Failure
Unplug and contact the store you purchased or
Sharp Service Center.
small trace of ozone which may produce odor.
This is not harmful to health.
Loudness can be changed depending on a room
humidity, but the effectiveness is the same.
Relocate the Plasmacluster Ion Generator if
necessary.
E-8
IG-A10EU
(Low)
(Low)
10
1.8
345 (W D H)
2.5
6.5
72
3
can