Initial Colour Balance Setting; Auto Colour Calibration - Sharp AR-C260 Key Operator's Manual

PROGRAMS FOR COPY MODE

Initial colour balance setting

Colour balance settings that have been adjusted
using the special "Colour Balance" function
explained on page 6-14 of the "Operation Manual
for general information and copier operation" can
be called up and set as initial colour balance
settings* by storing them ahead of time in a job
program (page 6-26 of the "Operation Manual for
general information and copier operation"). Use
this feature when you want to repeatedly use
settings for a favorite colour or for correction when
a change occurs in the colour balance.
* Preset values displayed when you select the
special "Colour Balance" function. The factory
default settings are the "0" position for all eight
levels of each colour.
When the [INITIAL
SETTING] key is touched, the following display will
appear.
KEY OPERATOR PROGRAMS
INITIAL COLOUR BALANCE SETTING
PRESS PROGRAM NUMBER IN WHICH COLOUR BALANCE PROGRAM IS REGISTERED.
1 2
6 7
RETURN TO THE FACTORY DEFAULT
If a job program number key is touched that does
not have colour balance settings, a warning
message will appear.
To return colour balance settings that have been
stored as initial settings to the factory default
settings (the "0" position for all eight levels of each
colour), touch the [RETURN TO THE FACTORY
DEFAULT SETTINGS.] key.
14
COLOUR BALANCE
OK
3 4 5
8 9 10
SETTINGS.

Auto colour calibration

The Auto Colour Calibration program enables
automatic colour gradation correction when the
colour is off.
NOTE
The colour gradation may not be sufficiently
corrected after one correction cycle. If so, execute
the program again.
When the [AUTO COLOUR CALIBRATION] key is
touched, the following display will appear.
KEY OPERATOR PROGRAMS
AUTO COLOUR CALIBRATION
USE 11"X17" OR A3 PAPER FOR THIS ADJUSTMENT.
PRESS [EXECUTE] TO PRINT THE TEST PATCH.
After the [EXECUTE] key is touched and a test
patch printed, a message appears asking you to
begin automatic adjustment. Place the test patch
on the document glass as shown below and touch
the [EXECUTE] key.
Yellow
Black
Magenta
Cyan
NOTE
Lay approximately five sheets of copy paper that
are the same size as the test patch on top of the set
test patch, and gently close the original cover.
When a message appears informing you that auto
colour calibration is completed, touch the [OK] key
to end the procedure.
NOTE
Before executing this program, check to see if the
registration adjustment is correct. If not, execute
[AUTO ADJUSTMENT]
adjustment] on page 10.
OK
EXECUTE
in [Registration